![]() ![]() Switch S2: USB/ Arduino TEL0051 Module directly connects with PC through USB port/ Module communicates with Arduino board Switch S1: Comm/ Prog PC communicates with TEL0051 Module/ Arduino Programming Removing the jumpers will release the above Pins, and you could connect the driver pins to the other digital pins on your board to avoid the pin conflict. Embeded high-gain SMD antennas for GPS & GSMĪpplying the Module Pin Jumpers(J10-J12) will allocate Pin 3,4,5 for driving the module.Support GPS technology for satellite navigation.Power supply: Low power consumption - GSM mode).This GPS/GPRS/GSM shield uses an embedded SIM908 chip from SIMCom.Featuring an industry-standard interface and GPS function, the combination of both technologies allows goods, vehicles and people to be tracked seamlessly at any location and anytime with signal coverage. It includes a high-gain SMD antenna for GPS & GSM. And the design of this shield allows you to drive the GSM & GPS function directly with the computer and the Arduino Board. It is controlled via AT commands(GSM07.07 ,07.05 and SIMCOM enhanced AT Commands). It's possible for your robot and control system to send messages and use the GSM network. It also supports GPS technology for satellite navigation. ![]() This shield with a Quad-band GSM/GPRS engine works on frequencies EGSM 900MHz/DCS 1800MHz and GSM850 MHz/PCS 1900MHz. This is a GPS/GPRS/GSM arduino shield from DFRobot. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |